|
Introducing Speed Bleeder... The automotive bleeder screw with the built-in check valve that makes bleeding your brakes truely a one person job! Simply remove your OEM bleeder screw and replace it with Speed Bleeder. When you are ready to bleed your brakes loosen the Speed Bleeder 1/4 turn. Pump the brake lever or pedal until bubble free fluid is seen. Close the speed Bleeder and you are done. Anyone can do it! MODELS AND APPLICATIONS (specify in the comments section after ordering): All 2nd gen TT cars use four (4) SB1010 speedbleeders per car. If your 1st gen TT car uses a 7 mm wrench for rear bleeder screws (reportedly 3/92-5/93), then you need two (2) SB1010 speedbleeders and two (2) SB7100 speedbleeders per car. Else, it they are all four (4) SB1010 speedbleeders. If your NA car uses a 7 mm wrench for bleeder screws, then you need four SB7100 speedbleeders. StopTech and most Brembo calipers use SB1010S short speedbleeders. They have a M10x1 thread and a 31.35 mm body. These calipers require two SpeedBleeders per each brake caliper. Most AP Racing calipers use SB1010 speedbleeders. They have a M10x1 thread and a 34.44 mm body. These calipers require two SpeedBleeders per each brake caliper.
| Available Options: |
| Model: |
|
| Quantity: |
|
|
