$2,745.00

*SCE Torsen AWD-Center Limited Slip Differential
[SCE-LSD-AWD]

*SCE Torsen AWD-Center Limited Slip Differential
The Supercar Engineering torque biasing Center differential enables your car to accelerate quicker and corner faster. How? By reducing the understeer and by sending the power to the wheels that could use it!

The SCE Helical AWD Center Differential powers both front and rear wheels. The drive torque will be distributed between the front and the rear wheels in the most optimal way proportionate to the available traction. This is a Torsen-type torque-sensing differential with a 40/60 asymmetrical front/rear torque split. The torque split changes automatically between 60/40 and 20/80, depending on the available traction. This virtually eliminates the power-on understeer. The max torque capacity is 16,000 ft*lbs for aggressive drag launches.

Even if your stock VCU is not blown, the amount of torque that it could generate is not impressive. A good stock VCU can be slowly turned by hand, so the torque is less than 10 ft*lbs. In a typical road course 3rd gear, the VCU rotates about 1.5 times slower than the engine. If the engine generates the stock 320 ft*lbs, then on a stock car 55% of that goes to the rear. If the front wheels lose a little bit of traction, the rear torque would (after some slippage and a time delay) increase by only 10/1.5/320 = 2%, up to 57%. In lower gears, or on higher HP cars, it would be even less. But with the SCE Torsen center diff, the rear torque would instantly increase from 60% up to to 80%, even for high-HP cars, and in any gear.

This differential is for all AWD 3/S cars. The '94 - 99 model year 6-speed and the '92.5 - 93 model year 5-speed version comes with a special modified version of a 25-spline 300M output shaft. The '91 - early 92 model year 5-speed version comes with a special 18-spline 300M output shaft.

NOTE: The version for a 5-speed 18-to-25-spline conversion requires either a "Front Output Shaft" from a 5-speed 25-spline transmission or a modified 5-speed 25-spline Front Output Shaft (not included, sold separately for a nominal fee, please inquire). NEW! No special 25-spline bell housing is needed!

NOTE: A good usable and non-damaged OEM center differential housing core is required. The core should be returned within 60 days for a full core charge refund. The core could also be sent to SCE in advance before the shipment to avoid the core charge. After the 60 days the core refund will be $100. We also buy good used OEM differential housings at the market price.

The SCE AWD Center Differential comes with something else others don't have: a Limited Lifetime Warranty. This warranty applies even when raced! This warranty does not apply to the 300M output shaft, however no 300M shaft has been broken yet.

Available Options:

Application:

Core OEM center diff housing:

Reviews

Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x AEM 5 Gallon Tank Kit for Water Injection Kit
1 x AEM No-Weld O2 Sensor Mount 3 Inch
1 x AEM Boost Gauge -1 to 2.4BAR w/Analog Face
1 x AEM 5 BAR / 75 PSIa MAP Stainless Steel Sensor Kit
1 x AEM Plug-N-Pin Kit for EMS
1 x AEM EMS Sensors and Replacement Parts
1 x AEM Oil Temp Gauge 100-300F
1 x AEM Peak & Hold Injector Driver
1 x AEM Stainless Manifold Bung Install Kit
1 x AEM No-Weld O2 Sensor Mount - 2.5 Inch
1 x AEM Boost Gauge -30 to 35PSI w/Analog Face
1 x AEM Boost Gauge 0 to 60PSI w/Analog Face
1 x AEM 8 Channel Twin Fire Ignition Module
1 x AEM 500 PSIg Stainless Steel Sensor Kit
1 x AEM 35-2610 Plug-N-Pin Kit
1 x AEM Oil Pressure Gauge 0 to 100 psi
1 x AEM 4-Channel K-Type Thermocouple Amplifier
1 x AEM EMS Plug-N-Play Engine Management
1 x AEM No-Weld O2 Sensor Mount - 2 Inch
1 x AEM EGT Gauge 0-980C with Analog Face
1 x AEM Recirculation-Style Water/Methanol Injection Pump
1 x AEM 1 BAR / 15 PSIa MAP Stainless Steel Sensor Kit
1 x AEM AQ-1 Data Logger
1 x AEM Replacement Relocation Harness
1 x AEM Boost Pressure Gauge 0-15PSI with Analog Face
1 x AEM 3.5 Bar Or 50Psia Brass Sensor Kit
1 x AEM AQ-1 96" Flying Lead Wiring Harness
1 x AEM Fuel Ignition Controller
1 x AEM EGT Gauge 0-1800F with Analog Face
1 x AEM 100 PSIg Stainless Steel Sensor Kit
1 x AEM Boost Control Solenoid Kit
1 x AEM Engine Position Module for Chevy Small & Big Block Engines
1 x AEM High Output Inductive "Dumb" Coil
1 x AEM 150 Psig Brass Sensor Kit & Flying Lead
1 x AEM AQ-1 18" Flying Lead Wiring Harness
1 x AEM Adjustable Fuel Pressure Regulator
1 x AEM Exhaust Back Pressure Sensor Install Kit
1 x AEM 1 Gallon Water/Methanol Injection Kit
1 x AEM MAP
1 x AEM EGT Sensor Installation Kit
1 x AEM No-Weld O2 Sensor Mount 3.5 Inch
1 x AEM 2000 PSIG Sensor Kit Universal
1 x AEM Oil Pressure Gauge 0-100PSI w/Analog Face
1 x AEM Transmission Temperature Gauge 40-148C w/Analog Face
1 x AEM 100 PSIg Brass Sensor Kit
1 x AEM AQ-1 Mini Harness
1 x AEM Boost Gauge 35-50 psi
1 x Competition Clutch Stage 5 - Strip Series 1420 Clutch Kit
1 x StopTech BBK - 3000GT/Stealth Turbo '91-99 - ST-40 380x32mm kit
1 x Supercar Engineering "Big Reds" Rotor-only Upgrade Kit - 13"x32m
1 x *KAAZ AWD-Rear Limited Slip Differential
1 x Competition Clutch Ultra Lightweight Steel Flywheel
1 x Competition Clutch Lightweight Flywheel
1 x NGK G-Power Platinum Spark Plug
1 x Competition Clutch Stage 3.5 - Street/Strip Series Clutch Kit
1 x Competition Clutch Kit Stage 2 - Street Series 2100
1 x TEIN HTECH Lowering Springs
1 x EXEDY OEM Replacement Clutch Kit
1 x NGK Laser Iridium Spark Plug
1 x SPC Alignment Components - EZ Cam XR
1 x ST Springs - SportTech
1 x Tein S-Tech Lowering Springs
1 x Supercar Engineering W-I-D-E Front Brake Rotor Upgrade, 3000GT/S
1 x Competition Clutch Kit Stage 4 - Strip Series 0620
1 x Competition Clutch Stage 4 - Strip Series 1620 Clutch Kit
1 x HKS D1 Limited Edition Radiator Cap
1 x StopTech Slotted Brake Rotors, 3000GT/Stealth Turbo 94-99, Rear
1 x Metra Universal Power Antenna
1 x BLE Solid Race Tensioner
1 x NGK Standard Spark Plug
1 x 3000GT/Stealth 91-99 Gauge Pod 52mm Single
1 x StopTech Slotted Brake Rotors, 3000GT/Stealth Turbo 94-99, Front
1 x Caliper Seals (3S Turbo only)
1 x Supercar Engineering 2-Piece Floating Rear Brake Upgrade, 3000GT
1 x NGK Iridium IX Spark Plug
1 x 3000GT/Stealth 91-99 Gauge Pod 52mm Dual
1 x Supercar Engineering 4-Wheel Rotor Upgrade, 3000GT/Stealth Turbo
1 x BLE Solid Lifters Conversion Kit
1 x Koyo Radiator - R-Series
1 x NGK Laser Platinum Spark Plug
2 x Supercar Engineering Cam Gear Lockers
1 x NGK V-Power Spark Plug
1 x Mishimoto Performance Aluminium Radiator
1 x Magnecor 8.5mm Wires Sets - Mitsubishi, Dodge Stealth
1 x StopTech Slotted Brake Rotors, 3000GT/Stealth Turbo 91-93, Rear
1 x MSD Ignition Super Conductor Spark Plug Wire Set
1 x Metra Radio Wiring Harness for Mitsubishi
1 x Mishimoto Radiator Fan Shroud Kit
1 x StopTech Slotted Brake Rotors, 3000GT/Stealth Turbo 91-93, Front
1 x Supercar Engineering EGR Block-Off Plates, CNC Engraved
1 x Digital Inclinometer (Camber Tool)
1 x APR Longer Wheel Studs (+24mm)
1 x Ksport Big Brake Kit - 3000GT/Steath FWD NA 330x32mm Rotors
1 x Carbotech Panther XP-8 - 3000GT/Stealth Turbo 91-99 - Front
1 x KAAZ Differential Oil (GL-5/80W-90) - 2L Can
1 x Walbro HP Fuel Pump
1 x * Supercar Engineering 3 mm Wheel Spacers
1 x USED 3000GT/Stealth Turbo Transmission Parts
1 x Getrag transmission synchro rebuild services
1 x * Supercar Engineering 5 mm Wheel Spacers
1 x *Wing GTC-500 Universal [Carbon Fiber]
1 x Supercar Engineering "Big Reds" Brake Kit - 3000GT/Stealth Turbo
$30,998.43
Manufacturer Info
Supercar Engineering
Other products
Share Product
Share via E-Mail
Share on Facebook Share on Twitter
We Accept